www.janitza.de
47
Busbar tap-off unit
WARNING
Risk of injury due to electrical voltage!
Severe bodily injury or death can result! Therefore
please abide by the following:
·
Switch off your installation before commenc-
ing work! Secure it against being switched on!
Check to be sure it is de-energized! Ground
and short circuit! Cover or block off adjacent
live parts!
·
During operation and troubleshooting (espe-
cially for DIN rail devices), check your system
for dangerous voltages and switch these off if
necessary!
·
Wear protective clothing and protective
equipment in accordance with applicable
guidelines when working on electrical sys-
tems!
·
Before making connections, ground devices,
modules or components at the ground wire
connection, if available!
·
Do not touching bare or stripped leads that
are energized! Equip stranded conductors
with wire ferrules!
·
Hazardous voltages can be present in all cir-
cuitry parts that are connected to the power
supply.
·
Protect your wiring, cables and devices (mod-
ules, components) with a suitable line circuit
breaker/fuse!
·
Never switch off, remove or tamper with safe-
ty devices!
·
There can still be hazardous voltages present
in the device or in the component even after
it has been disconnected from the supply
voltage (capacitor storage).
·
Do not operate equipment with current trans-
former circuits when open.
·
Only connect screw terminals with the same
number of poles and design!
·
Do not exceed the limit values specified in
this user manual, in the usage information for
the devices (modules, components) and on
the rating plate! This must also be observed
during testing and commissioning.
·
Observe the safety and warning notices in the
usage information associated with the devic-
es modules and components!
9.3
Product safety
The product reflects current engineering practice
and accepted safety standards, but hazards can
arise nonetheless.
Observe the safety regulations and warning no-
tices. If notices are disregarded, this can lead to
personal injury and/or damage to the product.
Every type of tampering with or use of this prod-
uct,
·which goes beyond the mechanical, electrical or
other operating limits can lead to personal injury
and/or damage to the product.
·constitutes “misuse” and/or “negligence” under
the product’s warranty and thus voids the war-
ranty for any possible resulting damage.
Read and understand the associated usage in-
formation before assembling/installing, operating,
maintaining and using the product.
Only operate the product when in perfect
condition and in compliance with this supple-
mentary user manual. Please also observe the
usage information of the installed measure-
ment devices and components!
Send defective products back to the manufacturer
in compliance with the transport conditions.
Retain the usage information of the busbar tap-off
unit throughout the service life of the product and
keep it available for reference.
When using the product, also observe the legal
and safety regulations for your system that are
applicable for the respective use case.
9.4
Dangers when handling the product
When operating electrical products, certain parts
can inevitably conduct hazardous voltage. Con-
sequently, severe bodily injury or material damage
can occur if they are not handled properly.
Therefore, always observe the following when
handling our products:
·Do not exceed the limit values specified in this
user manual, the usage information on the mea-
surement devices (modules, components) and
on the rating plate! This must also be observed
during testing and commissioning!
·Safety information and warnings in all usage
information that belongs to the products!
