Janfire
pelletswärme
swedish quality
13 Electric power supply
The connection to the grid has to be done by an expert. We require an earth leakage circuit breaker
and a 16 amp. fuse. All wiring has to be temperature proofed up to 120°C. We advice to use silicon
cable.
14 Setting into operation
The Combiflame has to be set into operation by a Janfire certified expert. We do not take any
response for any damage which is founded in a not proper setting into operation of the boiler.
15 Usage by the customer
pellet burner:
Read the manual of the NH pellet burner before usage too. Start and adjust the burner as said in the
manual. Make sure that the ash pit is empty and the main heat exchanger and the catalytic converter
are clean. Do not open any door of the boiler during operation of the pellet burner.
log or brown coal:
1.
Make sure that the ash pit is empty, the main heat exchanger and the catalytic converter are
clean.
2. Make sure that the pressure of the domestic water supply is proper.
3.
Adjust the firing controller to your needed temperature. Close the bottom door of the boiler.
4.
The Combiflame is filled with log or coal through the upper door.
• Adjust the firing controller to 60°.
•
Heat up the boiler to 60°.
• Adjust the length of the cain so that the draft flap is open for 1mm at the bottom.
• Adjust the firing controller to your wished temperature.
