JANE TWINLINK, Manual

Page: 23 / 76

23
EN
B. FITTING AND REMOVING THE WHEELS
insert the wheel axle into the chassis axle until you hear it click
firmly into place. Make sure that they are securely attached.
1
To remove the rear wheels, press the button found on the brake
bar and pull the wheel
2
To fit the front wheels, keep the front locking button pressed down,
slot the front wheels into the axle and push upwards. Release the
front locking button. You should feel the wheels slot firmly into
place. Make sure that they are securely attached.
3
To remove the front wheels, press the front locking button and
remove the front wheel by pulling it downwards.
3
WARNING : Never fit or remove the wheels while the baby is
in the pushchair.
WARNING : Take the wheels off the chassis from time to time
and remove any dirt or sand from the wheel axle. Use a
brush and a damp cloth to clean the dirt off the wheels.
C. UNFOLDING AND FOLDING
UNFOLDING
To open your TWIN-LINK, place it on a flat surface with the handle-
bar facing upwards and release the folding lock found on the left
rear leg of the chassis 4 . a and lift the handlebar upwards until it is
fully opened and you hear the main locks slot into place. 4 .b - 4 .c
WARNING : Before using your TWIN-LINK pushchair, make
sure that all the fastening and locking devices are correctly
engaged and locked.
FOLDING
Before folding your TWIN-LINK pushchair, put the parking brake on
6 . a always remove the SMART soft carrycot, take any objects out of
the basket that could prevent the pushchair from closing properly,
release the steering lock on the front wheels 7 .a and close the hood
14
.b
Slide the safety button to the left and simultaneously press the cen-
tral button under the handlebar 5 . a push the handlebar forwards
5
.b -
5
.c so the pushchair folds up completely.
Always make sure that the chassis folding lock is securely fastened
to prevent the pushchair from coming open while being carried 5 . d
!
!
!