JANE Be Cool Twister, Manual

Page: 56 / 132

EN
56
Adjust the headrest by pulling the headrest adjustment
handle, raise or lower according to your child’s height.
Release the handle ,the headrest and the shoulder
belts reach the desired height and you will hear a“click”.
The harness strap should be level with your child’s
shoulders. Check that the headrest is properly engaged
by sliding the headrest down a little.
For child height: 100-150cm. Press the strap adjust-
ment button, adjust the headrest by pulling the
headrest adjustment handle, raise or lower according
to your child’s height. release the handle, the headrest
will reach the desired height and you will hear a“click”.
1.6 Usage of the support leg
1. Unfold and pull the support leg away from the
bottom of the enhanced child seat until it locks in
place.
2. Hold the support leg and pull it out forward from
the bottom of the base and make it fully extended
until you can hear a “ click”. Now the support leg is
locked in place and you can use the support leg.
3. Place the enhanced child seat forward facing on a
vehicle seat.
4. Hold and press support leg adjustment button and
pull out the lower section from the upper section of
the support leg until it rests firmly on the floor of the
vehicle. The support leg indicator at the bottom of the
support leg must be fully green.
Important ! It is not allowed to place objects under the
support leg. For information on the storage compart-
ments in the foot area please contact your vehicle
manufacturer.
Make sure that support leg must never be suspended
in mid-air or supported by other objects.
Make sure that the support leg does not lift the
bottom of the base of the child seat up from the
surface of the vehicle seat.