Jandy SHPF, Installation And Operation Manual, Page: 5 / 24

Page 5
CAUTION
This pump is for use with permanently installed pools and may also be used with hot tubs and spas if so
marked. Do not use with storable pools. A permanently installed pool is constructed in or above the ground
or in a building such that it cannot be readily disassembled for storage. A storable pool is constructed so
that it may be readily disassembled for storage and reassembled to its orig i nal integrity.
CAUTION
Do not install within an outdoor enclosure or beneath the skirt of a hot tub or portable spa. The pump
requires adequate ventilation to maintain air temperarture at less than the maximum ambient temperature
rating listed on the motor rating plate.
SAVE THESE INSTRUCTIONS
WARNING
Chemical spills and fumes can weaken pool/spa equipment. Corrosion can cause filters and other equipment
to fail, resulting in severe injury or property damage. Do not store pool chemicals near your equipment.
CAUTION
Do not start pump dry! Running the pump dry for any length of time will cause severe damage and will
void the warranty.
WARNING
To minimize risk of severe injury or death the filter and/or pump should not be subjected to the piping
system pressurization test.
Local codes may require the pool piping system to be subjected to a pressure test. These requirements
are generally not intended to apply to the pool equipment such as filters or pumps.
Jandy ® pool equipment is pressure tested at the factory.
If however the WARNING cannot be followed and pressure testing of the piping system must include the
filter and/or pump BE SURE TO COMPLY WITH THE FOLLOWING SAFETY INSTRUCTIONS:
• Check all clamps, bolts, lids, lock rings and system accessories to ensure they are properly installed
and secured before testing.
• RELEASE ALL AIR in the system before testing.
• Water pressure for test must NOT EXCEED 35 PSI.
• Water temperature for test must NOT EXCEED 100°F (38°C).
• Limit test to 24 hours. After test, visually check system to be sure it is ready for operation.
• Notice : These parameters apply to Jandy
®
equipment only. For non-Jandy
®
equipment, consult
equipment manufacturer.