Jandy SHPF, Installation And Operation Manual, Page: 12 / 24

Page 12
Section 5. Service and Maintenance
5.1 Routine Maintenance
The pump will collect any large debris present in
the water at the pump basket. As debris accumulates
it will begin to block the flow of water through the
pump, and must be removed. The cleaner the basket
is kept, the more effective and efficient the pump will
perform. The pump lid is clear for easy inspection
between cleaning.
1. To clean the basket, turn off the power to the
pump. If the pump is located below the water
level, close the isolation valves on the suction and
discharge sides of the pump to prevent backflow
of water. Turn the lid counter-clockwise until it
comes off. You may use a tool for leverage to
remove the lid, but
never to tighten the lid.
CAUTION
A misaligned basket will cause the lid to be
improperly seated, allowing an air leak which could
result in pump damage.
2. Lift the basket out of the pump.
3. Dispose of the debris and thoroughly clean the
basket, making sure all the holes are open. Using
a garden hose, spray the basket from the outside
to help clear the holes. Use your hands to remove
any remaining debris.
4. Replace the basket in the pump by aligning
the opening with the suction pipe. If aligned
properly, the basket will drop easily into place.
Do not force into place.
5. Prior to replacing the lid, check for debris around
the lid o-ring seat, as this will cause air leaks into
the system. Clean the lid o-ring and place on the
lid.
6. Hand-tighten the lid to make an air tight seal. Do
not use any tools to tighten the lid, hand-tighten
only.
7. Verify that all valves have been returned to the
proper position for normal operation.
8. Open the pressure release valve on the filter, and
make sure it is clean and ready for operation.
9. Turn on the power to the pump. Once all the
air has been evacuated from the filter, close the
pressure release valve.
5.2 Winterizing the Pump
CAUTION
The pump must be protected when freezing
temperatures are expected. Allowing the pump
to freeze will cause severe damage and void the
warranty.
CAUTION
Do not use antifreeze solutions in the pool,
spa, or hot tub systems!
Antifreeze is highly
toxic and may damage the circulation system.
The only exception to this is Propylene Glycol. For
more information see your local pool/spa supply
store or contact a qualified swimming pool service
company.
1. Drain all water from the pump, system
equipment, and piping.
2. Remove the two drain plugs. Store the drain
plugs in a safe location and reinstall them when
the cold weather season is over.
Do not lose the
o-rings.
4. Keep the motor covered and dry.
NOTE Covering the pump with plastic will create
condensation and this moisture will damage the
pump. The best way to protect your pump is to
have a qualified service technician or electrician
properly disconnect the electrical wiring at
the switch or junction box. Once the power is
removed, the two unions can be loosened and the
pump stored indoors. For safety, and to prevent
entry of contaminants, reinstall all conduit and
terminal box covers.
5. When the system is reopened for operation, make
sure all piping, valves, wiring, and equipment
are in accordance with the manufacturer's
recommendations. Pay close attention to the
filter and electrical connections.
6. The pump must be primed prior to starting; refer
to
Section 4.1, Start-up .