Page 20
7.2.2 Setting the Temperature Scale
The LJ controller can display all temperature
readings in either degrees Fahrenheit or degrees
Centigrade. Once the temperature scale is entered, it
may take up to 30 seconds to update the inlet water
temperature. To set the display to the desired 'TEM-
PERATURE SCALE' perform the following steps:
1.
Press the MODE key repeatedly until the icon
'°F/°C' appears at the top of the display screen.
2.
Press the ENTER key. The temperature scale
indicator in the lower left corner of the display
will start to flash.
3.
Press the UP or DOWN key to toggle between
°F and °C.
4.
When the temperature scale is set to your
preference, press the ENTER key. The tempera-
ture scale indicator will stop flashing and the
word 'NORMAL' will appear in the upper left
corner of the display screen to indicate that the
desired temperature scale has been set and the
heater is now in normal operating mode.
7.2.3 Setting Pool and Spa Temperatures
The LJ controller has dual temperature modes,
which allows two different temperature settings,
selected by the SELECTION key on the bottom of the
control panel. One mode can be set for normal use and
the other for standby; or one can be set for pool and
the other for a spa. This feature makes it easy to
switch between heating the pool and heating the spa
by eliminating the need to change the thermostat
setting to the desired temperature each time the switch
is made.
NOTE: The temperature set range for both the
'POOL' and 'SPA' settings is 70°F (21°C) to 104°F
(40°C). If an attempt is made to set a temperature
outside of this range, the words 'INVALID COM-
MAND' will appear on the left side of the display.
To set the 'POOL WATER TEMPERATURE'
perform the following steps:
1.
Press the MODE key repeatedly until the words
'POOL SET' appear at the top of the display
screen.
2.
Press the ENTER key. The temperature indica-
tor in the lower left corner of the display will start
to flash.
3.
Press the UP or DOWN key to adjust the
desired temperature.
4.
When the temperature is set to your preference,
press the ENTER key. The temperature indicator
will stop flashing and the word 'NORMAL' will
appear in the upper left corner of the display
screen to indicate that the desired pool tempera-
ture has been set and the heater is now in normal
operating mode.
To set the 'SPA WATER TEMPERATURE'
perform the following steps:
1.
Press the MODE key repeatedly until the words
'SPA SET' appear at the top of the display
screen.
2.
Press the ENTER key. The temperature indica-
tor in the lower left corner of the display will start
to flash.
3.
Press the UP or DOWN key to adjust the
desired temperature.
°F
°F / °C
°C
NORMAL
POOL SET
80°F
87°F
NORMAL
SPA SET
102°F
104°F
Summary of Contents for Lite2 LJ Series
Page 45: ...Model LJ Pool and Spa Heater Page 43 NOTES...
Page 46: ...Page 44 NOTES...