background image

Lid Seal & Lid O-ring

R0449100

Pump Debris

Trap Basket

R0448900

Align the slot of the basket with the

position tab inside of the pump body.

Lid with 

Locking Ring

and Seal

R0448800

Lid O-ring

Lid Seal

NOTE

    The Lid Seal has

a three-lobed cross section

and the Lid O-ring has a

round cross section.

These instructions are to be used with the following Jandy Pro Series Replacement Parts:

R0448800-- Lid with Locking Ring and Seal Replacement Kit (PHPF/PHPM, WFTR, MHPM)

R0448900-- Pump Debris Trap Basket Replacement Kit (PHPF/PHPM, WFTR, MHPM)

R0449100-- Lid Seal and Lid O-ring Replacement Kit (PHPF/PHPM, WFTR, MHPM)

PHPF/PHPM, WFTR, and MHPM Pumps, Lid w/ 

Locking Ring and Seal,   Lid Seal and Lid O-ring, 

and Basket, Replacement Kit Instructions

     WARNING

Before servicing the pump, be sure to switch off the circuit breaker to the circuit supplying electrical power to the pump. Failure 

to do so could result in property damage, severe personal injury, and/or death.

Figure 1. Exploded View of PHP, WFTR, and MHP Pump Parts

1. Introduction

This document contains instructions for the prop-

er replacement of the lid with locking ring and seal, the 

lid seal or lid o-ring, and the pump debris trap basket on 

Jandy Pro Series PlusHP (PHP, Models PHPF/PHPM), 

Water Features (WFTR) and MaxHP (MHP, Model 

MHPM) Pumps. 

These replacement kits are designed to be used 

with both newer and older model Jandy PHP, WFTR, 

and MHP Pumps. Refer to Figure 1 and the parts list on 

this page to identify the parts in each kit.

These instructions must be followed exactly. 

Read them completely before starting the procedures.

Parts List

  Description

R0448800

R0448900

R0449100

Lid with Locking Ring

1

--

--

Lid O-ring

--

--

1

Pump Debris Trap Basket

--

1

--

Lid Seal

1

--

1

Instructions

1

1

1

 

WARNING

FOR YOUR SAFETY:

 

This product must be installed and serviced by a contractor who is licensed and qualified in pool 

equipment by the jurisdiction in which the product will be installed where such state or local requirements exist. The maintain-

er must be a professional with sufficient experience in pool equipment installation and maintenance so that all of the instruc

-

tions in this manual can be followed exactly. Before installing this product, read and follow all warning notices and instruc-

tions that accompany this product. Failure to follow warning notices and instructions may result in property damage, personal 

injury, or death. Improper installation and/or operation will void the warranty.

H0281300 Rev E

Summary of Contents for PlusHP Series

Page 1: ...e lid seal or lid o ring and the pump debris trap basket on Jandy Pro Series PlusHP PHP Models PHPF PHPM Water Features WFTR and MaxHP MHP Model MHPM Pumps These replacement kits are designed to be used with both newer and older model Jandy PHP WFTR and MHP Pumps Refer to Figure 1 and the parts list on this page to identify the parts in each kit These instructions must be followed exactly Read the...

Page 2: ...ousing Debris on lid sealing surfaces can cause air leaks in the system WARNING Follow all filter manufacturer s instructions Never attempt to assemble disassemble or adjust the filter when there is pressurized air in the system Starting the pump while there is any pressurized air in the system can cause the filter lid to be blown off which can cause death serious personal injury or property damag...

Page 3: ...use the filter lid to be blown off which can cause death serious personal injury or property damage 1 Comply with the warnings and follow steps 1 5 in Section 2 1 Opening Pump 2 Lift the pump debris trap basket out of the pump 3 Before installing the new debris trap basket remove all debris from the pump 4 Place the new pump debris trap basket into the pump Make sure that the slot of the basket is...

Page 4: ...manufacturer s instructions on how to bleed all air from the filter WARNING Follow all filter manufacturer s instructions Never attempt to assemble disassemble or adjust the filter when there is pressurized air in the system Starting the pump while there is any pressurized air in the system can cause the filter lid to be blown off which can cause death serious per sonal injury or property damage 4...

Reviews: