TROUBLESHOOTING
ROTISSERIE
ROTISSERIE NOT TURNING
Is the access door completely closed? If not, a safety switch prevents the unit from
operation.
Is the Motor Running?
YES – Then check the chain connection between the motor sprocket and the upper
sprocket on the rotisserie shaft. If the chain is broken, then either repair the chain
(usually with a master link) or replace the chain. If the chain is okay, then check the
connector between the upper sprocket and the shaft. The upper sprocket is connected
or secured to the shaft with a key and a keyway with a set screw.
NO – Check the electrical supply panel for a tripped circuit breaker. If tripped, then
reset. Then check the motor overload contact assembly. This is located inside a gray
ROTISSERIE MOTION IS NOT SMOOTH
Make sure that the load on the rotisserie is balanced.
If equipped with star turners, check the tension on the star turners (see separate page
which follows). New disc springs may be required.
If equipped with a planetary gear action, check the chain tension on the individual
spits. There is an idler sprocket that can be used to take up slack in the chain.
If the motion still does not smooth out then replace the bushings on the drive side.
SPITS DO NOT SNAP INTO PLACE
Replace the compression springs.
electrical enclosure near the motor. Push the
reset button
to
reset the motor. If the
motor still does not turn, call a service technician to
troubleshoot the wiring and
the motor.
Page 7
Summary of Contents for ROTISSERIE
