Specifications
16
1.0 Operations
5. Lower the conveyor so you can remove the telescoping spout from the discharge end of the conveyor.
6. Swing the collapsible hopper end out from under the Speed Tender shell.
7.
Place the collapsible hopper in the up position (Figure 1.6)
8.
With the discharge end lower than the collapsible hopper end, place the discharge end into a 5 Gal. bucket
(Figure 1.9). Using the hand held controller, start the conveyor and run until completely empty.
9.
Lower the collapsible hopper end back down to the ground. This will allow you to open the clean-out door.
(Figure 1.10)
10.
Place collapsible hopper in the down position.
CAUTION: If you are parked on an incline, the conveyor may swing freely. (It is advised that you do not use
Speed Tender on uneven ground).
11.
With the conveyor at a 45 Deg. angle, swing the conveyor hopper back under the tank and slide ball back into latch system.
Replace both pins on latch handles.
12.
Position conveyor above conveyor rest and lower to allow its full weight on the conveyor rest.
13.
Engage spring latch into conveyor rest.
Be sure spring latch is fully engaged
.
14.
Make sure the collapsible hopper is in the up position for storage (Figure 1.6).
NOTE: This will help the water drain out of the hopper.
15.
Slide the fuel shut off lever to the “OFF” position. This will allow the engine to shutoff by running out of gas.
16.
Turn the key to the “OFF” position.
Figure 1.9
Figure 1.10
Conveyer Clean-
out Door