Product Description
This exiting new J&M Performance Series 4-channel ampli-
fier kit has been designed specifically for use in the 2006-
2013 Harley® RoadGlide fairing, with the Harley HK radio
along with a second set of speakers (4 total) mounted in the
rear saddlebag or trunk pod position. (may also work with the
1998-2005 Harley RoadGlide fairing/radio, under the certain
conditions below)
This is a full range class D amplifier and is spec’d at 90watts
RMS per channel X4 channels, driven continuous into a
2 ohm load @ 14.4vdc.
Amplifier mounts to the custom made metal mounting
bracket system.
Custom made plug-n-play wiring harnesses are included
with this amplifier kit, top quality heavy gauge power/ground
wires are used for the fused battery connection, along with
all necessary mounting hardware & complete installation/
operation instructions.
Amplifier itself measures 7 ¼” X 4 ¾“ X 1 ¾”.
Installation Instructions
1. Remove the outer fairing shell, seat, and fuel tank.
2. By following along the factory wiring harness, route the
amplifier power harness from the fairing, under the fuel tank,
and on to the battery. (removal of the fuel tank is necessary for
proper installation)
3. Then route the rear speaker wiring harness along the
same path as the power harness to the rear speaker mounting
location.
4. After first disconnecting the negative battery cable from
the battery, connect the positive (red) lead from the amplifier
power harness directly to the positive post of the battery. Then
connect the negative (black) lead from the power harness to
the same bolt/stud on the frame that the negative battery cable
is connected to. Then reconnect the negative battery cable to
the battery.
(Figure A)
Do not connect the negative (black) lead
from the amplifer to the negative post of the battery.
remove
remove
Fig. B
IMPORTANT NOTE: Some 1998 thru 2005 model Road-Glides require the replacement of the factory grill assembly/speaker adapters in order for
the J&M amp kit and/or 7.25 speaker kit to be installed. It will be necessary to remove the outer fairing and inspect the factory installed grill/adapter
assemblies to determine if they need to be replaced. The early style assemblies can be identified by the method of attachment to the inner fairing.
If the screws attaching the speaker go completely through the grill/adapter and into the inner fairing mounting bosses you have the early style
assemblies and they will need to be replaced with the later style factory grill/adapter assemblies and mounting hardware listed below. The later style
grill/adapter utilizes independent hardware to attach it to the inner fairing then the speaker is attached to the grill/adapter with 4 additional screws. If
you have the later style assemblies, the J&M amp kit and/or 7.25 speaker kit will fit with no additional parts or hardware needed.
UPGRADE PARTS AND HARDWARE TO BE PURCHASED FROM YOUR HARLEY DEALER IF NEEDED
77021-98B LH SPEAKER GRILL KIT (Hardware included)
77022-98B RH SPEAKER GRILL KIT (Hardware included)
76234-05 SCREW PHILLIPS HEAD (8 needed)
BATT
+
Red
Master Frame
Grounding Stud
Negative
Battery Cable
Fuse
Black
Heavy Gauge
Amplifier Power/Ground
Wire Harness
Rear Speaker
Wiring Harness
Left Rear Speaker
Right Rear Speaker
(Green &
Green/Brown)
(Brown &
White/Brown)
Fig. A
