14
Set-Up Instructions
Install the Tie Rod
•
Before installing the tie rod, slide the two center support brackets pictured below onto the bar. Slide the larger brace towards the
rear of the header transport and the smaller brace towards the front. Insert the guide blocks and secure using the original hardware.
While inserting the guide blocks, ensure all holes line up. The guide blocks are two different parts and must line up correctly.
•
Adjust both clevis ends so that the holes in the clevis ends line up with the holes in the hitch top plate.
•
Use (2) 3/4” shoulder bolts and (2) 3/4” shoulder bolt nuts to attach both ends of the push pull rod.
Install the Center Support Brackets
•
Place the upper bar center support brackets on the header transport. The small bracket will straddle the support in the middle of the
header transport (as shown below). Place the large bracket on the corresponding bar so they are aligned. Put the 1/2”-13 x 5” hex
bolts and 1/2”-13 centerlock hex nuts into place and leaving loose until the next step.
Summary of Contents for 4WS17
Page 2: ......
