12
Set-Up Instructions
Mounting the Front and Rear axles
•
Set both of the bottom frame bars on two sawhorses or blocks.
NOTE: Place 4” blocks under the small lower bar so the ends are level. The small lower bar is the bar without the truss
picutured below.
Non-Trussed Lower Bar
•
Attach the front and rear axles to the frame bar using (8) 5/8” x 6” hex bolts, (8) 5/8” centerlock hex nuts and (2) frame tube end
plates. Tighten all hex nuts.
•
If your header transport includes the optional spare tire mount, the spare tire mount replaces the rear frame tube end plate.
Trussed Lower Bar
•
Attach the front and rear axles to the frame bar using the wing saddle lower bases, (8) 5/8” x 6” hex bolts, and (8) 5/8” centerlock
hex nuts. The U-bolt and (2) 5/8” centerlock hex nuts need to be tightened. Picture is shown on the bottom right hand corner of
this page.
*optional
Without Truss
Trussed
Summary of Contents for 4WS17
Page 2: ......
