IS230-12H
J&D Manufacturing • 6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398 • www.jdmfg.com
Page 4of 4
7
6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398
Visit our website at www.jdmfg.com
B
• Install manual disconnect switch inside building adjacent to
fan per national, regional,and local electrical codes.
• Route wire to motor with drip loop and secure. Drip loop will
drain accumulated moisture away from the motor.
• Configure internal wires to match supply voltage and wire
according to motor nameplate. Test to verify correct rotation.
• Only permit power to unit when shutter and guard is fully
installed to prevent injury.
Separate variable speed control is required to adjust fan speed.
Contact your dealer for more information.
MAINTENANCE INSTRUCTIONS
• Disconnect power before cleaning or maintaining your fan in order
to prevent serious injury or death.
• Service and repair of fan should only be completed by a qualified
technician.
• For maximum efficiency and fan life, keep the following free from
dirt and dust:
-
blades
-
housing
-
motor
-
guard
• The totally enclosed air over motor has sealed ball bearings and
does not require additional lubrication.
ALL ELECTRICAL WORK SHOULD BE
COMPLETED BY QUALIFIED PERSONNEL
AND MEET NATIONAL, REGIONAL
AND LOCAL CODES.
A
• Plug cord into 115 AC grounded outlet that meets national,
regional and local codes.
• Route electrical cord from motor to outlet with drip loop.
Drip loop will drain accumulated moisture away from the
motor and outlet.
• Only permit power to unit when shutter and guard is fully
installed to prevent injury.
Separate variable speed control is required to adjust fan speed.
Contact your dealer for more information.
POWERING UNIT
The Poly Chiller fan is available with or without a pre-wired cord. If the
model you purchased includes an attached cord, proceed to step A for
instructions on powering your fan. If you purchased a model without a
cord, proceed to step B for wiring instructions.