10
blood pressure will be measured !
Note:
Only use approved cuffs!
• A loose cuff or a sideways protruding air pocket causes false measurement values.
• With repeated measurements, blood accumulates in the wrist, which can lead to false results.
Consecutive blood pressure measurements should be repeated after a 1 minute pause or after
your wrist has been held up in order to allow the accumulated blood to flow away. If you decide
to take your Averaging Mode measurement again, be sure to wait at least one minute
beforehand.
5.3. Fitting the Cuff
Please refer to picture-04
a) Remove all jewelry and watches. The palm of your hand should be facing you. Apply the cuff
so that the display is facing you.
b) The distance between the cuff and the hand should be 1cm.
c) Secure the cuff with the hook and loop adhesive so that it lies comfortably and not too tight.
It should be comfortable.
d) Lay your wrist on a table with your palm upwards. Support your wrist with a cushion so that
the cuff rests at about the same height as the heart. Remain still for 2 minutes, sitting quietly,
before beginning a measurement.
Picture-04
5.4. Measure Procedure
Refer to picture 05
The monitor is designed to take measurements and store the measurement values in
memory for two people using User ID A and User ID B.
1. Sit comfortably in a chair with your feet flat on the floor.
2. Select your User ID (A or B).
Stretch your wrist forward on the desk and keep relaxing, make sure the palm of hand is