background image

DE - Darüber hinaus beachten Sie unbedingt folgende 

      weitere Hinweise:

•   Wenn Sie im Modell kein BEC einsetzen laden Sie vor jedem 

  Einsatz den Empfängerakku auf, beachten Sie die Hinweise 

  des Herstellers der jeweiligen Zellen.

•   Bevor Sie den Empfänger einschalten stellen Sie sicher, dass 

  der Gasgeber auf Motor-Aus steht.

•   Stellen Sie sicher, dass der Sender und der Empfänger richtig 

  zusammen arbeiten, richtig gebunden sind.

•   Schalten Sie immer zuerst den Sender und dann den Empfän-

  ger ein.

•   Schalten Sie immer zuerst den Empfänger, dann den Sender

 aus.

•   Führen Sie vor dem Start einen Reichweiten- und einen Funk-

  tionstest durch.

•   Beim Einsatz zielen Sie nicht mit der Senderantenne auf das

  Modell, da der Sender in dieser Richtung nur eine geringe

  Abstrahlung hat. Halten Sie die Antenne in einer seitlichen

  Stellung zum Modell.

•   Gefährden Sie weder Menschen noch Tiere.

•   Setzen Sie die Anlage bzw. das zu steuernde Modell nur in  

  geeignetem Gelände ein.

•   Bei Sturm, Regen oder einem Gewitter dürfen Sie Ihre Anlage

  nicht einsetzen.

•   Wenn die Anlage länger nicht eingesetzt wird, entfernen Sie 

  die Batterien aus dem Sender.

•   Entsorgen Sie verbrauchte Batterien und nicht mehr zu

  reparierende elektronische Bauteile ordnungsgemäß.

An der Anlage dürfen keinerlei Veränderungen vorgenommen 

werden. Dadurch entfällt jeder Anspruch auf Gewährleistung.

GB - Furthermore, the following should be strictly 

       adhered to:

•   The receiver battery must be charged before every fl ying 

 session.

•   Before Switching on the system ensure that throttle stick is in 

  the off position.

•   Check that the transmitter and receiver are compatible and 

  bonded to one another.

•   Always switch the transmitter on fi rst and then the receiver.

•   Always switch the receiver off fi rst and then the transmitter .

•   Complete a full range and function test before every take-off.

•   When fl ying, do not point the transmitter antenna directly at 

  the model as in this confi guration the signal is at it‘s weakest.

  Try to keep the antenna at right angles to the model.

•   Never over-fl y people and do not allow your model to 

  endanger people or animals.

•   Do not fl y near to over-head cables, buildings or airfi elds.

•   The system must not be operated in rain, or thunder storms.

•   If you do not intend to use the transmitter for a long period,

  remove the batteries.

•   Dispose of batteries and electronic waste correctly. These 

  item should not be placed in the household rubbish in most 

 countries.

 

The system may not be altered in any way, doing so will void the

guarantee.

3

Haftungsausschluss

Jamara e. K. übernimmt keine Haftung für Schäden, die an dem 

Produkt selbst oder durch dieses entstehen, sofern diese auf fal-

sche Bedienung oder Handhabungsfehler zurückzuführen sind. 

Der Kunde allein trägt die volle Verantwortung für die richtige 

Bedienung und Handhabung; dies umfasst insbesondere die 

Montage, den Ladevorgang, die Verwendung bis hin zur Wahl 

des Einsatzbereiches. Bitte beachten Sie hierzu die Bedienungs- 

und Gebrauchsanleitung, diese enthält wichtige Informationen 

und Warnhinweise.

 

Indemnity Statement

Jamara e.K. is not liable for any damage caused to the product 

itself or through this, provided this is due to improper operation or 

handling errors. The Customer alone bears the full responsibility 

for the proper use and handling, including without limitation, the 

assembly, the charging process, the use and choice of the ope-

ration area. Please refer to the operating and user instructions, it 

contains important information and warnings.

Entsorgungshinweise

Bitte sorgen Sie für fachgerechte, den gesetzliche 

Vorschriften entsprechende Entsorgung der Elektro-

bauteile (Fernsteuerung, Ladegerät und Modell usw.). 

Bitte werfen Sie diese nur in die dafür vorgesehenen 

Sammelboxen bei den Kommunen.

Disposal Instructions

All parts of this model should be disposed of correctly, 

in particular electronic components may be subject to 

local restrictions. Your dealer will advise you.

Fernmeldebestimmung

Beachten Sie die Fernmeldebestimmungen in dem Land in dem

Sie das Modell einsetzen möchten! Bei Fragen wenden Sie sich

bitte an unseren Service oder direkt an Ihren Fachhändler.

Wir weisen darauf hin, dass die Verantwortung für den ord-

nungsgemäßen Einsatz einer Funkfernsteuerung beim An-

wender liegt. Beachten Sie bitte die rechtliche Lage in Ihrem

Land!

Communications Regulations

Please observe all rules and regulations referring to the use of 

radio signals (radio control) which may be in force within the 

country where you are operating your model, any queries should 

be addressed to your dealer.

Please Remember! The operator is solely responsible for

the use of radio signals and for his model. Please ensure

that you acquaint yourself with all laws which may apply to

you before you operate your model.

Summary of Contents for CX 2,4 GHz









Reviews: