Jamara BD-5, Instruction, Page: 5 / 16

5
11. Fuselage, upper part:
Use 3 mm ply on the left and right side and it is lapping over.
The fin is later fitted in the gap.
12. Straighten the fuselage borders and glue to the grooves.
The front lower fuselage is covered with 2 mm balsa and
sanded the edges to the sides around
13. Glue both 1.5 mm ply rings together
15. The fuselage sides are reinforced with 1.5 mm ply parts to
hold the swing tail.
Now the lower small frame and the rear fuselage (1.5 mm
balsa) are glued in place.
14. Apply the ring as shown.
The adapters are a longer in the lower part compared to the
upper part.
Down thrust is set at 5 - 7˚ up.
16. The fuselage nose is applied in layers and later sanded.