5
MANUAL for JAKKA ADVANCED CONTROLLER
1) Use standart junction box.
Hole distance must be 60mm
center to center.
Use 68mm hole saw.
2) Remove the
front panel
using a thin-
blade flat
screwdriver.
3) Secure the
rear panel by
screwing screws.
Necessary
screws are in the
box.
4) Make the
cable connecti-
ons as shown
below to termi-
nals on the front
panel.
5) Attach the clip
at the top first,
and then attach
the clip at the
bottom.
10. MOUNTING INFORMATION
(2 x 2 x 0,34...0,75mm²)
Shielded, Twisted Pair, RS485 Data Com-
munication Cable must be used.
Note : Press the terminal buttons with
the help of a fine-tipped pen as shown
in the figure. Don't apply extreme
pressure.
NOTE: DON’T USE THE SCREWDRIVER
11. CONTROL PANEL CABLE CONNECTIONS
