JAI TM-1325 Series, User Manual

Page: 16 / 40

TM-1325 Series
8 Installation
2.2.5 Digital Output Cable (TM-1325 Only)
The TM-1325 camera uses the cable 30DG-02 from JAI, Inc. as a digital output cable. This cable has a 31-pin
AirBorn connector on the camera end and a 37-pin D-sub male connector on the other end. Contact your JAI,
Inc. representative regarding availability of interface cables for specific framegrabber models. Pinout
configuration for the digital cable is shown below.
Figure 6. Pinout Configuration for Digital Output Cable
2.2.6 Camera Link Cable (TM-1325CL Only)
The MDR26 cable assembly (26CL-02-26) used for the Camera Link cable has the 26-pin MDR26 connector on
both ends. This is a straight-through cable. The pin-out configuration is shown in Table 4 on page 6.
Note: For TM-1325CL, serial communication for camera control is done via the Camera Link connector on the
rear panel of the camera.
Cable assemblies and boardmount receptacles can be ordered from 3M.