SW-4010Q-MCL-M52 User Manual (Tentative)
Preparation
- 24 -
Step 4: Configure Basic Settings for the Camera
Note:
On this camera, you must configure both the RGB and SWIR channels individually.
Configure the Camera Output Formats
Configure the pixel formats of the image output from the RGB and SWIR channels.
1. To check the current pixel format setting of the RGB channels, enter the command
BA?<CR><LF>
from the terminal emulator software. The default setting is RGB8 (BA=0).
2. To change the pixel format setting to RGB10BasePacked, enter
BA=1<CR><LF>
.
3. To check the current pixel format setting of the SWIR channel, enter the command
IRBA?<CR><LF>
from the terminal emulator software. The default setting is Mono8
(IRBA=0).
4. To change the pixel format setting to Mono10, enter
IRBA=1<CR><LF>
.
For more information, see the following Short ASCII command table.
Item
Short ASCII
Command
Values
Command Examples
RGB
PixelFormat
BA
0: RGB8 (Default)
1: RGB10BasePacked*
2: RGB12BasePacked*
BA=[Param.]<CR><LF>
BA?<CR><LF>
SWIR
SWIRPixelFormat
IRBA
0: Mono8 (Default)
1: Mono10
2: Mono12
IRBA=[Param.]<CR><LF>
IRBA?<CR><LF>
Caution:
*The RGB10BasePacked and RGB12BasePacked formats are customized pixel
formats for the Camera Link interface. To view image output in this format, a viewer that
supports these formats is required. For more information, see
.
