GO-5000M-USB / GO-5000C-USB
- 12 -
5.2 Computer to be used
It is necessary to use a PC equipped with a USB 3.0 interface. It is also recommended to use a PC
equipped with slots of better than PC Express 2.0 x 8. Please note that the GO-5000-USB may not
work properly depending on the chipset used in the PC.
5.3 JAI SDK and Control Tool software
The GO-5000M-USB and GO-5000C-USB are designed to use the JAI SDK and Control Tool software to
control camera functions. All controllable functions are stored in the camera’s XML file. The JAI SDK
can be downloaded from
www.jai.com. Third-party software can also be used with the camera
provided it is compliant with the GenICam
®
standard.
5.4 Cables to be used
As for the USB connector, GO-5000-USB uses a Micro B connector which complies with USB 3.0. This
connector has an additional 5-pin plug “stacked” on the side of a standard USB 2.0 Micro B
connector. However, USB 2.0 cannot be used with the GO-5000-USB.
5.5 AC Adapter/Trigger
In the GO-5000-USB, the USB 3.0 interface is capable of supporting both data and power.
GO-5000-USB is also equipped with a 6-pin connector which can optionally be used to connect to a
separate power supply, as well as providing an optical interface for external I/O such as a trigger
pulse.
5.6 Camera Default Settings
When the camera is connected to a PC and JAI SDK 2.0 is started up, an XML file which stores default
settings of the camera is downloaded to the JAI_SDK camera control tool.
The default settings of the GO-5000-USB are as follows.
Table – 1 Default settings
Image Format
Bit allocation
8-bit
Height
2048
Binning Horizontal (Note) OFF
Binning Vertical (Note)
OFF
Trigger Operation
Trigger Mode
OFF
Exposure Control
Exposure Mode
OFF
Gain
Gain Auto
OFF
Manual Gain all
0
Manual Fine Gain all
0
Analogue Base Gain
0dB
Note: GO-5000M- USB only.
