CV-M4
+
/M4
+
CL, CV-M7
+
/M7
+
CL
- 21 -
6.9. Other Functions.
Functions which can be controlled by either RS-232C or switches, or both.
Gain and set-up.
!! Do not adjust these settings unless you have knowledge to video adjustments!!
The video gain is set to
manual
. In manual gain mode, either the
gain level (GA)
or the
rear
potentiometer (RP).
can adjust the level.
Set-up level. (SU).
This setting can adjust the set-up level (or black level).
Vertical Binning (BI).
Only vertical binning is possible. It can be selected by the command BI=1,
or by the internal switch SW301-6. (Off 0 normal, ON = V-binnig.)
Binning is only for CV-M4+ and M4+CL.
When binning is active, the horizontal time H is changed from 39.3
µ
sec. to 43.3
µ
sec. It will
result in longer exposure times in Edge Pre-Select shutter mode PE.
SYNC/EEN output. (SE).
Will select SYNC or EEN signal output on pin #9 on 12-pin connector.
Trigger polarity. (TP).
Will invert the trigger-input signal.
LEN/FEN/EEN polarity. (FP).
Will invert the LEN, FEN and EEN output signal.
Important notes on using this functions.
•
Do not attempt to adjust the set-up level without knowledge to it.
•
Do not attempt to use ASCII commands not shown in “7.5. CV-M4
+
command list.”
