18
5M
ATT
01-03-2013
15:43:35
00002
/
15797m
[
]
Note: Allow approximately 10-20 seconds for the camera
to acquire a cellular signal. If “LOGIN FAIL” appears on
the display, move the selector switch OFF and repeat
steps. The 5 db booster antenna (accessory) is necessary
for cellular operation in low signal areas.
5. The camera has successfully acquired a cellular signal
when six numbers or the service provider’s initials appear on
the display. Failure to connect will prevent the camera from
sending texts and photos via MMS.
6. Place the camera at the target area at least five feet above
ground level using a T-Post and T-Post Camera Mount. This
will ensure the camera has the correct angle to trigger the PIR
motion sensor and IR illuminators are above the target area.
7. Slide the selector switch from
SETUP
to
ON
. Close and
latch the camera within ten seconds before the Ambient Light
Sensor LED stops blinking red and the PIR triggers a photo.
8. Ensure the camera takes a photo to verify it is positioned
and programmed correctly. The camera will take photos or
videos based on the
MENU
selections. The M.I.N.E.™ Cam is
now operational and active.
NOTE: If the Ambient Light Sensor LED does not stop
blinking, the selector switch is still in the SETUP position.
The camera must be ON to function.
The M.I.N.E.™ Cam training video can be viewed online
with the entire M.I.N.E.™ Trapping System video series at:
www.youtube.com/JAGERPRO
Summary of Contents for M.I.N.E. CAM
Page 1: ...1 ...
