Tool change
Item no. 10206008, Revision 00
30 ( 40 )
10.2
Manual hollow shank taper
1
Clamping segment
2
Access hole
3
Locking ring
4
Threaded spindle
5
Marking "X"
6
Snap ring
7
Ejector with withdrawal thread
8
Basic body
9
Driver
10
Cam
11
Shaft of HF spindle
12
Mounting spindle
Example of design: Joining position
Example of design: Clamping
position
Ü
Turn the locking ring until the hexagon wrench can be guided axially
through the access hole to the hexagon socket of the mounting screw.
Ä
Width across flats: 3
Ü
Turn the threaded spindle counterclockwise until you feel it reach the stop.
Ü
Remove the hexagon wrench.
Ü
Before inserting the tool mount into the HF spindle, clean the following:
Ä
Plane surfaces of tool mount
Ä
Taper of tool mount.
Ä
Plane surfaces of shaft.
Ä
Inner taper of shaft.
Ü
Use the cleaning taper from the service set.
Ü
Insert the tool taper into the HF spindle.
Ä
See figure: Joining position
Ü
Insert the hexagon wrench into the threaded spindle through the access
hole.
Ü
Tighten the threaded spindle clockwise with the tightening torque M
A
max.
Ä
M
A
max: 6 Nm
Ä
See figure: Clamping position
