12
BRIZA EC
E / 27200.23700029 - 7 september 2016 3:49 PM - Jaga N.V.
Please follow and keep these instructions!
Are conform to the CE Directive :
NBN EN60335-1 based on EN60335-1-2002 + a11:2004 + a1:2004 + a12:2006 + a2:2006 + a13:2008 + A14:2010 + A15:2011
NBN EN 60335-2-80 based on EN 60335-2-80:2003 + A1:2004 + A2:2009
Instructions for start-up
Instructions to dismantle the unit and dispose of hazardous substances
ATTENTION!
Start-up and Commissioning of the unit (where applicable) must be carried out by skilled personnel,
qualified to work on this type of product.
Before starting up, make sure the installation and electrical connections have been carried out in com-
pliance with the instructions in this manual. Also make sure that there are no unauthorised persons in
the vicinity of the unit during the above operations.
SAFEGUARD THE ENVIRONMENT
Jaga N.V. has always cared about protecting the environment.
When the unit is dismantled it is important to strictly following theseprocedures:
• the unit must be dismantled by a firm authorised for the disposal of scrap machinery/products
The unit as a whole is composed of materials considered as secondary raw materials and the following
conditions must be complied with:
• if the appliance contains antifreeze, this should not just be disposed, as it causes pollution
• it must be collected and disposed of properly
• the electronic components (electrolytic condensers) are considered special waste, and must be de-
livered to a body authorised to collect such items
• the pipe insulation made of polyurethane foam, polyethylene foam mesh and the sound-absorbing
sponge that lines the panelling must be removed and processed as urban waste
Preliminary checks before start-up
Before starting up the unit,check if:
1.
the unit is positioned correctly
2.
the supply and return pipes of the hydraulic unit are connected and insulated properly;
3.
the pipes are clean and bled
4.
the inclination of the unit towards the drain and the siphon are correct
5.
the exchangers are clean
6.
the wiring connections are correct
7.
the screws that secure the conductors are clamped
8.
the supply voltage is that required
9.
the electric fan consumption is correct and does not exceed the maximum allowed value
It is advisable to run the unit at maximum speed for several hours.
