Assembly Standard Operation Procedure
Placement Requirements
! For Outdoor Use Only. Install only in well-ventilated areas.
Do not locate the firepit:
In high traffic areas
Under or near trees, plants and buildings where debris may constantly fall into the firepit. Excessive debris
will require high maintenance and/or cause malfunctioning of the firepit.
In places where people, children, and pets may contact the firepit. Guards or fences around the firepit in
these locations are recommended.
Clearances:
NOTE
: All clearances are measured from the outside edge of the firepit.
The distance from any structure or combustible material to the firepit perimeter shall be a minimum of
50ft. Lesser clearances shall be used only where acceptable to the local authority having jurisdiction.
The distance from any overhanging foliage (trees, shrubs, and so on) to the firepit shall be a minimum of
20 feet
Before You Begin
! Read this entire manual before you use your new firepit. Failure to follow the instructions
may result in property damage, bodily injury, or death.
NOTE: The sections of the firepit are heavy, and may require two people to lift them into place.
Tools Needed
See assembly SOP
Installation Instructions
NOTE: The nuts, bolts, and washers attaching the firepit to the pallet are used for installation. Do not throw
these away after detaching the firepit from the pallet.
1. Determine the location of the firepit. Make sure all clearances are met as per our requirements.
2. Prepare the firepit location. We recommend compacted sand or gravel under the firepit, or solid surfaces
like concrete. Do not operate this Fire-pit on any deck or patio.
4
FORM #006310 REV. 1
