Removing and refitting wristlets
To alter the wristlet of your Master Compressor Diving, you
can remove and refit the wristlet sections.
Removing the wristlet
Refitting the wristlet
Hold the case in one hand, with
the watch placed crystal down
on a support.
With the other hand grip the
“fork” tool supplied with the
watch, and slide it between the
horn and wristlet, in order to
grip the wristlet bar between the
teeth of the fork.
Make sure that the tool is cor-
rectly positioned on the bar, on
the retractable end of its spindle.
The bar is equipped with a spin-
dle mounted on a spring, which
needs to be released. To do so,
press the tool onto the bar’s
retractable end, sliding it on lat-
erally (from the opposite side of
the horn) to move the spring.
Once the spring has been
released, take out the bar, and
pull the wristlet section towards
you to extract it.
Bar retractable
end
Insert one end of the bar into
the hole in the horn of the case,
and hold it firmly.
Take the tool supplied, and posi-
tion it on the free retractable
end of the bar. Holding the tool
in this position, press sideways
(from the opposite side of the
horn) to push the spring back
inside the bar.
Move the retracted bar to over
the housing hole in the horn,
and release it so as to engage
the spring.
Make sure that the wristlet is
properly fitted by pulling gently
on the section.
M
aster
C
oMpressor
D
iving
C
hronograph
gMt n
avy
seaL
s
- English
5/7
