Diving bezel
Your Master Compressor Diving Chronograph watch fea-
tures a unidirectional rotating bezel (i.e. one that can only be
turned anti-clockwise), with a mark every minute.
It can measure a particular time using the luminescent white tri-
angular marker as a reference point in relation to the hour hand
or minute hand.
To move the diving bezel, you need only grip it with two fin-
gers and turn it anti-clockwise to the desired position.
Adjusting the wristlet
Note: the wristlet illustrations below may not correspond to
either your wristlet or your watch, but the demonstration illus-
trated is completely identical and valid.
Adjusting the clasp
The clasp on metal bracelets and articulated rubber straps is
fitted with an adjustment system enabling you to lengthen or
shorten your wristlet by 4 mm on either side, for greater wearer
comfort.
Using the fine adjustment system
Switch from the long position to the short position:
Remove your watch.
Hold your clasp open between the thumb and forefinger of
one hand, with the wristlet section in your other hand (fig. 1).
Fig. 1
Lift up the clasp cover so
as to release the hinged
part of the wristlet section
from its groove (fig. 2).
Fig. 2 Long position
Push down the hinged
part of your wristlet sec-
tion and place it in its
groove, facing the oppo-
site way to its initial posi-
tion (fig. 3).
Fig. 3 Shortened position
The switch from the short
to the long position is
made in the same way, but
in reverse order (fig. 4).
Fig. 4 Extended position
M
aster
C
oMpressor
D
iving
C
hronograph
gMt n
avy
seaL
s
- English
4/7
