Jacuzzi SWIMSPA Series, Owner'S Manual

Page: 6 / 56

6
In case of long periods of inactivity, it is advisable to fully drain the system. Periodic drain-
age, during normal use, varies depending on the frequency of use, the contaminants and
the type of installation. Even if not used particularly frequently, you should change the
water at least once a month.
Prolonged sun exposure could damage the material of which the swim spa shell is
made, due to its capacity to absorb heat (dark colours in particular). Do not leave the
swim spa exposed to the sun without adequate protection when not in use (thermal
cover, gazebo, etc.). Any damage resulting from failure to observe these warnings
are not covered by the product warranty.
Live components and equipment (except those powered at very low voltage not
exceeding 12V) must be out of reach of individuals in the swim spa.
Jacuzzi® swim spas are class “1” appliances and must therefore be permanently connect-
ed, without intermediate junctions, to the electrical network and to the protection circuit
(grounding system).
Parts containing electrical components, with the exception of remote control devic-
es, must be positioned or fixed so that they cannot fall into the swim spa.
The appliance must be powered by means of a differential switch with operating
current which does not exceed 30mA.
The installer must use cables with a suitable cross-section with minimum characteristics
equivalent to type H 05 VV-F. Please refer to the corresponding section.
For the equipotential connection of the appliance the installer must use the terminal pro-
vided and identified by the ground symbol. Please refer to the corresponding section. It is
imperative to build a support base adequate to the load of the swim spa.
It is imperative to provide a drainage system for accidental water spills. Please refer to the
corresponding section.