Page 10
www.jacuzzi.com
Installation and Operation
English
Signature™ Collection
Signature™ Collection
ON/OFF Button
ON/OFF Button
Fig. 12
Whirlpool Control
In the closed position, the jets massage with
only water.
In the open position, air mixes with water
to create a deep, wide plume of massaging
bubbles.
Fig. 13
OPEN Position
CLOSED Position
Push down on the button to turn ON the whirlpool system.
Push down on the button to turn OFF the whirlpool system.
Direction
(Figure 14A)
To change the direction of the water flow, swivel the jet nozzle to
the desired angle.
Water Force
(Figure 14B)
Increase the force of the flow by rotating the jet face to the left
(counterclockwise).
Decrease the force of the flow by rotating the jet face to the right
(clockwise).
Never run the whirlpool system with all the jets closed.
Water Force
Direction
The heater turns ON automatically any time whirlpool
operation is active. Heater operation is not displayed on the
control panel. There is a visible indicator light on the heater
itself that signifies the heater is operating. The heater will
help maintain the temperature of the water in the bathtub
(Figure 15).
The heater is equipped with a preset vacuum switch which will
not allow the heater to turn ON if the pump is not running and
water is not flowing through the whirlpool system.
The heater includes an exclusive High-Limit switch. This safety circuit will not false trip from hot tap water. It will
only turn OFF the heater if the thermostat fails. To reset, press the button. If the high-limit trips frequently, please
contact us at www.jacuzzi.com, or at 1-800-288-4002.
Vacuum Switch
High-Limit Switch
PUSH TO RESET
OVER HEAT
PROTECTION
HEATER ON
High Limit Reset
Heater On
Fig. 15
Fig. 14A
Fig. 14B
Cleaning
If you want to use any kind of bathtub additive, use only a small amount of low-foaming powder or crystal substance;
the whirlpool action intensifies the foaming properties of soaps.
The use of certain bathtub oils, bubble baths, and bathtub additives may increase the level of accumulations of bathtub
residue in the whirlpool system and may cause false reading of the water level sensors. If excess accumulations
persist, you should discontinue use of these products.
To remove accumulations of bathtub residue from the whirlpool system, it is recommended that a bathtub be cleaned
regularly. For best results, however, we recommend that you clean your bathtub after each use using Systems Clean™,
our exclusive two-part plumbing system cleaner made specifically for whirlpool bathtubs. Systems Clean™ is available
through an authorized Jacuzzi Luxury Bath Distributor or by calling us direct at 1-800-288-4002 or may be purchased
online at www.jacuzzi.com.
CAUTION
CAUTION
Do not use oil or oil-based bathtub additives. Never use abrasive, or caustic, household
cleaners on any Jacuzzi Luxury Bath product.
RapidHeat
™
