8
CALL NOW
800.798.1779
SANCTUARY 1
www.infraredsauna.com
Assembly
Instructions Cont’d
The side wall panels connect to the back wall with the installed locking brackets. There are mating brackets on
the side of each panel.
1.
Place the left side wall in the slot in the floor.
Lift the side wall up about 4” (10cm) higher
than the backwall panel (See Picture 1).
2.
Place the side wall panel against the back
wall (See Picture 2), then slide down side
wall panel until the two panels are equal
height. (See Picture 3).
3.
If the panels are not equal height or there is
an obvious gap between the two panels, this
means they are not propery attached and
you should try again.
4.
Repeat the steps above for the right side
wall panel.
4 - CONNECTING SIDE WALLS
Picture 1
Picture 2
Picture 3
Right Side Wall Installed
Left Side Wall Installed
If the panels still seem too tight to come
down all the way, try backing off the
bracket screws by one half turn with a
Phillips head screwdriver on the female
bracket.
