Pure Air
®
Bath
Installation and Operation
www.jacuzzi.com
Page 7
English
Alternate
Access
12˝
(304mm)
18˝
(457mm)
18˝
(457mm)
12˝
(304mm)
Blower
Secondary
Access
Primary
Access
18˝
(457mm)
20˝
(508mm)
24˝
(609mm)
36˝
(914mm)
Blower
A
B
C
= Primary access
= Acceptable alternative if access
A
is not possible
= Secondary access for equipment (optional)
Left hand unit access is on the opposite side (mirror).
A
B
C
Figure 1 - Common Locations
Framing
•
Dimensions provided on rough-in diagrams are nominal.
Measure your actual unit upon receipt and build
according to the actual dimensions.
•
The floor structure beneath the bathtub must be able to
support the total weight of the bathtub, water and bather.
Please refer to the Technical Specifications Manual
(column marked ‘Total Weight/ Floor Loading’).
•
The unit must be supported from the bottom of the
bathtub and not from the bathtub rim. For drop-in
installations, take into account the thickness of the
surround material and finishing material (marble, tile,
etc.).
•
Ensure the rim will rest on a level surface.
•
Per code, access must be provided to the blower your
specific model. Primary and secondary service access
locations are shown in the rough-in diagrams contained
in the Technical Specifications Manual (Figure 1).
•
Provide adequate ventilation for cooling and supply
sufficient air for the blower. Do not insulate around the
blower.
•
Your bathtub may have blower parts that extend
beyond the rim of the bathtub. Refer to the rough-in
diagrams in the Technical Specifications Manual and
construct framing to correctly accommodate.
It is the responsibility of the installer, building
contractor, or owner to provide access for service.
Jacuzzi is not responsible for any costs relating to
obtaining access for repair. The owner shall bear
such costs and, if appropriate, must seek recovery
from the installer.
Frame out the space where the bathtub is to be located. The
following should be taken into consideration when preparing
the area: