Jacuzzi MORPHOSIS Omega, Use & Maintenance

Page: 30 / 84

30
I
TAPS, ALUMINIUM PARTS AND SEAT
Just dry the various components after use. If it should be nec-
essary to clean them, simply remove any impurities with a
soapy wet cloth or neutral detergent, rinse with clean water
and dry.
Do not use abrasive cloths, powder detergents, acetone
or other solvents.
I
NOZZLES (vertical hydromassage)
I
LARGE SHOWER HEAD
I
SHOWERHEAD
These components are equipped with a scale-removal filter,
which can be cleaned with a sponge. For normal cleaning op-
erations, see instructions for taps.
I
TRAY, PANELS
The shower tray is made of a special synthetic resin, which can
be cleaned simply by drying the surface after use. If there are
stains, any normal detergent or soapy water can be used.
Instead, if stains should persist, or if there should be burns or
light scratches, abrasive detergents can be used, by rubbing these
parts on the surface (with circular movements) with the
rough side
of a 2-sided sponge (one smooth and one rough), then rinsing
it carefully.
Do not use sodium hypochlorite based products (bleach,
hydrochloric acid solutions, etc.) and/or hydroxide based
products (caustic soda, etc.).
I
GLASS PANELS
The glass panels are protected by “ Crystal Clear”, a special treat-
ment that reduces the formation of scale and marks caused by
damp and shower products, leaving the glass panel easier to
clean.
“Crystal Clear” treatment reduces maintenance time and costs,
keeping the shower glass panels clean and bright over time (this,
however, depends on the degree of water hardness and how of-
ten the shower enclosure is used).
Maintenance is very simple: after using the shower enclosure,
rinse the glass panels with water, and if necessary dry them with
a cloth. Do not use abrasive pads and/or creamy or powdered
detergents.
Occasionally, when just rinsing does not leave it as clean and
bright as you would like, the glass panels can be cleaned with spe-
cial scale-remover detergents.
After a period of time, if you should notice that water does not
run off the glass panel so well, you can apply special products
that can aid this. For this type of maintenance, contact your
Jacuzzi
® Service Centre.
AL5
level sensor blocked or drain solenoid valve clogged
Displayed when you attempt to activate the Turkish bath
AL6
level sensor blocked or filling solenoid valve clogged
Displayed when you attempt to activate the Turkish bath
Maintenance