Luxury Whirlpool Bath
Installation and Operation
www.jacuzzi.com
Page 19
English
Do not use oil or oil-based bathtub additives.
If you want to use any kind of bathtub additive, use only a small amount of low-foaming powder or crystal substance;
the whirlpool action intensifies the foaming properties of soaps.
The use of certain bathtub oils, bubble baths, and bathtub additives may increase the level of accumulations of bathtub
residue in the whirlpool system and may cause false reading of the water level sensors. If excess accumulations
persist, you should discontinue use of these products.
Bathtub Additives
To remove accumulations of bathtub residue from the whirlpool system, it is recommended that a whirlpool bathtub be
cleaned at least twice a month. For best results, however, we recommend that you clean your whirlpool bathtub after
each use using, Systems Clean™, our exclusive two-part plumbing system cleaner made specifically for whirlpool
bathtubs. Systems Clean™ is available through an authorized Jacuzzi Whirlpool Bath Distributor or by calling us direct
at 1-800-288-4002.
Purging the Whirlpool System
RapidHeat
™
The heater turns ON automatically any time whirlpool operation is active. Heater operation is not displayed on the
control panel. There is a visible indicator light on the heater itself that signifies the heater is operating. The heater will
help maintain the temperature of the water in the bathtub.
Vacuum Switch
The heater is equipped with a preset vacuum switch which will not allow the heater to turn ON if the pump is not
running and water is not flowing through the whirlpool system.
High-Limit Switch
The heater includes an exclusive High-Limit switch. This
safety circuit will not false trip from hot tap water. It will
only turn OFF the heater if the thermostat fails. To reset,
press the button. If the high-limit trips frequently, please
contact us at www.jacuzzi.com, or at 1-800-288-4002.
PUSH TO RESET
OVER HEAT
PROTECTION
HEATER ON
High Limit
Reset
Heater
On
