Jacuzzi EN27 Series, Owner'S Manual

Page: 6 / 16

SECTION 3. GETTING STARTED
3.1 CONTENTS
The packaging should contain the following items:
• Robotic cleaner and floating cable
• Control box
• Transport and storage caddy
3.2 CONNECT TO A POWER
SOURCE
WARNING
Failure to comply with the following warnings can
result in permanent injury, electrocution or drowning.
PREVENT ELECTRICAL SHOCK
• U.S.: Per NEC® requirements, keep the control
box at least five (5) ft. (1.5 m) from the edge of
the pool.
CANADA: Per CEC requirements, keep the
control box at least three (3) m (10 ft.) from the
edge of the pool.
• Only connect the control box to a receptacle
protected by a ground fault circuit interrupter (GFCI).
Contact a certified electrician if you cannot verify that
the receptacle is protected by a GFCI.
• Do not use an extension cord to connect the control
box.
• Do not allow anyone to swim while the cleaner is in
the pool.
• The control box is water-resistant, not waterproof. In
order to prevent electrocution, never submerge the
control box or leave exposed to inclement weather.
• Firmly insert power cord connector (with TOP
shown facing up) until you hear a "click"
(Figure 1).
NOTE: The "click" indicates the power cord is connected
correctly.
“HAGA CLIC ”
“HAGA CLIC”
Figure 1. Connect Power Cable
NOTE: To disconnect, firmly grip the power cord
connector on each side, press the two tabs, and pull
out (Figure 2)
"CLICK"
"CLICK"
Figure 2. Disconnect Power Cable
6
ROBOTIC CLEANER