4.
Turn the mounting bracket upside down. Remove the Cat-5 network cable from the wire duct
and then route it through the groove on the bottom part of the mounting bracket or
alternatively through the cutout located between the two mounting key hole slots. Insert the
small tabs on the mounting bracket into the upper slots on the telephone base. Then press
the large tab on the mounting bracket and firmly push it into the lower groove on the
telephone base.
5.
Connect the Cat-5 network cable to the allocated network wall jack.
6.
Mount the telephone base on the wall by aligning the mounting key hole slots with the
mounting studs on the wall or wall plate. Then slide the telephone base down on the mounting
studs until it locks into place. Place the handset on the telephone base cradle and connect the
coiled handset cord to the telephone base if not already done.
Revision
Date
Author
Change Description
1.0
2016-12-08
LM
Initial Release.
