7 OPERATION
en-27
7.4
STARTING THE ENGINE____________________________________________________
Start the engine with the operator in the seat, steering controls
levers in the Neutral position, the PTO switch in the OFF position
and the parking brake engaged.
Set the throttle lever to half throttle.
RZT 2550KW and RZT 2760KW:
If the engine is cold, move the
choke to the choke position.
Turn the ignition switch to the RUN
position. The hour meter will
show the engine operation hours.
Turn the ignition switch to the START position. Release the key
when the engine starts. Allow 30 seconds between start tries to
allow the starter motor to become cool.
When the engine starts, move the choke to the RUN position. Allow the engine to become warm before you operate the
engine at full throttle.
7.5
TO STOP THE ENGINE _____________________________________________________
To stop and park the mower in normal conditions:
1.
Turn the PTO switch to the OFF position. Drive the mower to a flat and level area to park the mower.
2.
Put the steering control levers in the Neutral position.
3.
Lower the cutting unit to the ground. Engage the parking brake.
4.
Turn the ignition switch to the OFF position and remove the key before you leave the mower.
If an emergency occurs and you must park the mower in the area of operation, follow the guidelines set by the grounds
manager. If the mower is parked on a slope, chock or block the wheels.
NOTICE
Do not hold the ignition switch in the START position for more
than 5 seconds.
S
TOP
CHOKE
HR
Throttle
Lever
Hour Meter
Ignition
Switch
Choke
PTO
Switch
