OPERATION 7
en-28
7.4
STARTING THE ENGINE ____________________________________________________
Start the engine with the operator on the platform, the PTO
switch in the OFF position and the parking brake engaged.
Remove your hands from the steering control levers.
Set the throttle lever to half throttle. If the engine is cold, move
the choke to the choke position.
Turn the ignition switch to the RUN
position. The gauge will show
the fuel level and the engine operation hours.
Turn the ignition switch to the START position. Release the key
when the engine starts. Allow 30 seconds between start tries to
allow the starter motor to become cool.
When the engine starts, move the choke to the RUN position.
Allow the engine to become warm before you operate the engine
at full throttle.
7.5
TO STOP THE ENGINE _____________________________________________________
To stop and park the mower in normal conditions:
1.
Turn the PTO switch to the OFF position. Drive the mower to a flat and level area to park the mower.
2.
Remove your hands from the steering control levers.
3.
Lower the cutting unit to the ground. Engage the parking brake.
4.
Turn the ignition switch to the OFF position and remove the key before you leave the mower.
If an emergency occurs and you must park the mower in the area of operation, follow the guidelines set by the grounds
manager. If the mower is parked on a slope, chock or block the wheels.
NOTICE
Do not hold the ignition switch in the START position for more
than 10 seconds.
N
E
F
1/2
FUEL
S
TOP
CHOKE
Throttle
Lever
PTO
Switch
Ignition
Switch
Choke
Steering Control
Lever
Parking
Brake
