8 MAINTENANCE AND LUBRICATION CHARTS
en-43
8Maintenance and Lubrication Charts
8.1 MAINTENANCE CHART
Mower Service Interval Chart
Interval
Item
Section
First 50 Hours
•
Replace engine oil
•
Replace engine oil filter
•
Replace hydraulic oil filter
•
Check steering system
•
Check electrical wiring
•
Check fan belt tension
Each day (10 Hours)
•
Check Safety Interlock System
•
Check engine oil level
•
Check engine coolant level
•
Check hydraulic fluid level
•
Check tire pressure
•
Clean radiator and screens
Each week (50 Hours)
•
Lubricate all mower grease fittings
•
Check fuel lines and fittings
•
Check for loose components
Each Two weeks (100
Hours)
•
Check air filter
•
Check fan belt tension
•
Drain water from fuel system
•
Lubricate all reel grease fittings
Each month (250 Hours) •
Inspect hydraulic hoses and tubes
•
Check engine exhaust system
•
Check steering system
•
Check electrical wiring
•
Lubricate reel motor coupler splines
Each two months (400
Hours
•
Replace engine oil and filter
•
Replace fuel filter
Each 500 hours
•
Replace fan belt
•
Replace hydraulic oil and filter. (500 hours or yearly,
whichever comes first)
Yearly
•
Replace air filter
•
Replace radiator antifreeze
•
Lubricate wheel bearings (2WD Units)
50 Hour Grease Fittings
100 Hour Grease Fitting
A
-
Mower Pivot (1 per cutting unit)
H
- Reel Bearing Cavity (2 per cutting unit)
B
- Lift Arm Pivot (2 per cutting unit)
J
- Rear Roller (2 per cutting unit)
C
- Lift Cylinders (2 per cutting unit)
K
- Front Roller (2 per cutting unit)
D
- Steering Cylinder (2)
L
- Drive shaft (3)
E
- Steering pivot (2)
F
- Steering ball joint (2)
G
- Rear Axle Pivot
