MAINTENANCE 8
31
8.8
JUMP STARTING __________________________________________________________
Before attempting to “jump start” the mower, check the
condition of the discharged battery. See Section 8.7.
When connecting jumper cables:
1.
Stop the engine on the vehicle with a good battery.
2.
Connect RED jumper cable to the positive (+)
terminal on the good battery and to the positive (+)
terminal on the “discharged” battery.
3.
Connect the BLACK jumper cable from the negative
(-) terminal on the good battery to the frame
of the
mower with the discharged battery.
After cables have been connected, start the engine on
the vehicle with the good battery then start the mower.
8.9
CHARGING BATTERY _____________________________________________________
1.
Refer to
Section 8.7
. Read the Battery and
Charger’s manual for specific instructions.
2.
Whenever possible, remove the battery from the
mower before charging. If battery is not sealed,
check that the electrolyte covers the plates in all the
cells.
3.
Make sure the charger is OFF. Then connect the
charger to the battery terminals as specified in the
charger’s manual.
4.
Always turn the charger OFF before disconnecting
charger from the battery terminals.
WARNING
Batteries generate explosive hydrogen gas. To reduce
the chance of an explosion, avoid creating sparks
near battery. Always connect the negative jumper
cable to the frame of the mower with the discharged
battery, away from the battery.
!
WARNING
Charge battery in a well ventilated area. Batteries
generate explosive gases. To prevent an explosion,
keep any device that may create sparks or flames
away from the battery.
To prevent injury, stand away from battery when the
charger is turned on. A damaged battery could
explode.
!
