MAINTENANCE 8
33
8.11 LUBRICATION ____________________________________________________________
The mower was designed for minimum lubrication. Over
greasing will produce high loads on the bearings and
engine, thereby reducing the performance of the
machine.
1.
Always clean the grease fitting before and after
lubricating.
2.
Apply grease with a manual grease gun and fill
slowly until grease begins to seep out. DO NOT use
compressed air guns.
3.
For smooth operation of pivot points and other
friction points, apply several drops of SAE 30W oil.
Figure 8D
8.12 MAINTENANCE CHART _____________________________________________________
Recommended Inspection and Lubrication Intervals.
Daily
20
50
100
300
Yearly
Lubricant
Air Cleaner....................................... I ........................................C
Combustion Chamber........................................................................................................... C
Engine Oil ........................................ I .................. R ........................................R..........................................
...................... I
Fuel Line ............................................................................................................................................... R - 2 yrs
Spark Plug ..................................................................................................... A/R
Valve Clearance ................................................................................................................... A
Grease Locations (Figure 7C)
1 - Roller .......................................................... L.................................................................................... L
.................... II
2 - Height Adj. ........................................................................ L
............................................................................................ II
3 - RT Reel Shaft ............................................. L......................................................................................
..................... II
4 - Traction Roller............................................. L......................................................................................
..................... II
5 - Clutch Shaft Bearing .......................................................................................................................... L
.................... I
I
6 - Clutch Pivot Shaft .............................................................................................................................. L
....................III
7 - Clutch Needle Bearing ........................................................................................................................
................... III
★
8 - Traction Hub ........................... ................... L......................................................................................
.....................III
9 - Wheel Bearings ............................................................................................................ .................... L
.................... II
10 - Reel Clutch Lever ..................................... L......................................................................................
..................... II
11 - Chain Case ................................................................................................................. .................... R
....................IV
A - Add or Adjust C - Clean I - Inspect L- Lubricate R - Replace
Lubricants
I
-
SAE 10W-30 Classified API SF or SG.
II
-
Lithium Grease NLGI - Grade 2.
III
-
Lubriplate® grease, Jacobsen Part No. 5001581
IV
-
SAE EP-140 Oil - Drain and Refill
★
- Apply a light coat
NOTICE
All maintenance intervals must be performed more
frequently when operating in extremely dusty
conditions.
1
2
1
2
3
4
5
6
7
8
9
10
11
Summary of Contents for 63286G01
Page 34: ...9 NOTES 34 9 NOTES...
Page 55: ...55 INDEX 503478 2 503479 2 503532 49 62293 53...
