outside. Loosely fasten the bracket to
the chassis with ½” x 1 ½” hex bolts, lock
washers, and hex nuts provided. See
Figure 3. Repeat for the right side.
5. Take the seat prop rod attached to
the seat plate and remove. Take the
shorter prop rod provided, and install it
with the factory original hardware. See
Figure 4.
6. Now you are ready to start working
on the cab. Remove the front and rear
cab shipping brackets and lift the cab off
of the brackets.
7. Place one rubber isolator over each of
the cab brackets installed on the tractor.
Take the ½” x 3” hex bolts, 9/16” x 2 ½”
steel flat washers, rubber flat washers,
lock nuts, and ½” hex nuts, and prepare
to install the cab onto the tractor. Lift
the cab slowly over the tractor, centred
over the operator platform. Slowly lower
the cab towards the cab mounts. Be
careful when the cab reaches the seat, as
the cab will have to be maneuvered
around the seat to fit past it. Once the
cab is done, drop the fasteners into place
and loosely fasten as shown in Figure 5.
8. Once all ROPS fasteners have been
started, ensure that the cab is onto the
machine squared, and then torque up all
ROPS fasteners to the specifications
provided earlier.
9. Take the mower stabilizer bracket
and position on the mounts located on
the bottom windshield crossmember.
Use the 3/8” x ¾” flange bolts and nuts
NOTE: All references to left and right are taken from the operator’s point of view when he/she is
sitting in the driver’s seat.
Jacobsen 600 Series Mounting Instructions
Figure 4
Figure 5
Figure 6
