12/2/20
JACLO.COM
| PG 2
Sensing distance
POWER
Volume dispen
s
ed
Bottle Capacity
5~25cm
DC6V
Each time 1.0-2.0mL
1000mL
5. INSTALLATION
1)Install the faucet body
Fixation
plate
Button
Soap
bottle
(
1000mL
）
Control
housing
Liquid
tube
joint
This sensor soap dispenser is equipped with an infrared sensor
for activating the liquid soap dispenser pump;
In order to ensure
the proper installation and use, please read the following
instructions carefully. Improper installation or use may cause a
malfunction and/or void the warranty.
1. SPECIFICATIONS
2. IMPORTANT PRECAUTIONS
a)
Avoid excessive impact or force on the faucet body.
b)
Do
not
install this product in areas affected by strong
magnetic
force or sever
e
vibration.
c)
d)
Avoid exposure to direct sunlight.
Since the body of the product is composed of metallic
and molded parts, clean it with
common household
soap
and
a
soft cloth only.
e) Never use benzene, thinner or acid detergent.
f) If the sensor is stained with soap water or other impurities,
the product may malfunction.
3. PRODUCT STRUCTURE
4. INSTALLATION DIAGRAM
2)Install the control housing
(a)Put the control box bracket on the wall ,use a pencil to
draw two positioning holes, then use the impact drill to
drill two mounting holes; and push the expansive
plastics into the mounting holes, locking the control box
bracket on the wall with the M4×25mm screws.
Note : the control box bracket sh
ould
not be too far away
from the faucet body ,otherwise the two tubes cannot
be
connected
between the faucet body and the control
housing respectively.
(b)Pour soap into the soap bottle , and then tighten to the
(a)
(b)
Insert the faucet body in the central hole of the wash basin.
Put the sensor wire,
adapter wire,the air tube and the
liquid tube through the rubber washer and the nut,
then fix
the faucet body with the nut.
control housing.
3)Install the battery box
(a)Put the battery box on the wall ,use a pencil to draw a
positioning hole, then use the impact drill to drill one
mounting hole, and push the expansive plastics into the
mounting hole, then insert 2 / 3 of the screw into the
expanded rubber particles and hang the battery box on
the screw.
Expansive
M4
×
25screws
plastics
Sensor
Washer
Nut
Soap tube
≤
3
0
φ
26
5
5
0
-6
5
0
m
m
Unit:mm
Soap bottle
(1000ml)
Button
Control
housing
Check
valve
Air
tube
(
blue
)
Nut
Fixation
plate
Liquid
tube
Wall
Sensor
安装示意图
1
0
4
7
4
Battery
box
Red warter-
proof plug
Foam device
S
o a p
tube
4)Connect the tube line and wire line
(a)
Connet the liquid tube and air tube to the foam device.
(b)
Connect the black water-proof plug ,then lock the plug;
connect the red water-proof plug.
Connect air tube
(blue)
Connect control housing
Connect soap tube
jaclo
industries
| 129 Dermody Street Cranford, NJ 07016
p
908.653.4433 |
f
908.653.1717
