Jackson 24P-NSU, Service Manual, Page: 5 / 33

INSTALLATION INSTRUCTIONS
DECK MOUNTING OF DISHMACHINE
The dishmachine must be secured in place using the deck mounting tracks and caps
provided with machine.
STEPS : REFER TO FIGURE 1
1. Install the (4) adjustable feet provided into screw holes where shipping
bolts were removed earlier.
2. Adjust the level of the dishmachine by screwing the adjustable feet in or
out. The front of the machine should be adjusted 1/4" to 1/2" higher
than the back
3. Install the deck mounting hardware as shown in FIGURE 1 to the deck at
location where dishmachine will be permanently positioned. Install 3/8
inch stainless steel lug bolts to secure tracks and caps to deck.
4. Drill holes into deck as shown in FIGURE 1 and
insure rear holes are located 2-1/4 inch from wall.
5. The tracks and the rear end caps maybe tightened at this time.
6. Slide dishmachine onto tracks and into position at rear end caps.
7. Install front end caps into place and adjust if necessary to remove any
movement of machine, if possible, tack weld tracks to deck.
GRAVITY DRAIN SYSTEM
The drain from the dishmachine is a gravity drain system and should have the proper
drop from the machine to floor drain system.
STEPS : REFER TO FIGURE 2
1. Install hose to drain tube located at left rear of machine as shown in
FIGURE 2. Drain tube is 1-1/2 inches in diameter and 7 inches from floor.
[ PAGE 3 ]