7
Tools Required for Assembly:
Please use the proper tools to simplify installation and prevent injury or damage to your grill.
◼
Assembly Tools Required:
1
x
Large Phillips Screwdriver
1
x
Medium Phillips Screwdriver
◼
Assembly Tools Provided:
1
x
Hex Key for Control Knob removal
1
x
Hex Key for mounting wheels on cart
Assembling & Preparing your Grill:
◼
CHECK BURNER FIT on ORIFICES:
1.
Inspect burners to ensure that they are all inserted correctly onto
the orifices (AKA the outlet of the valves; Fig 1)
2.
If any burner is NOT correctly installed over the valve as shown in Fig 1, remove the
burner retaining clip, remove the burner, and reinstall correctly.
3.
Ensure each air shutter is set correctly – see correct flame characteristics on page 15
to see if it needs adjusting. Although we have pre-set the air shutters on the burners of
this product, it may be necessary to adjust them for optimum performance. This is an
outdoor appliance and geography and climate can necessitate an adjustment to the air shutters. The correct flame
characteristics can be found on page 15 of your owner’s manual.
◼
INSTALL FLAME DIFFUSERS & COOK GRIDS:
1.
Remove the flame diffusers, grids & warming rack from the packaging.
2.
Install each diffuser directly above each burner by setting them into the slotted ledges,
in the front and rear of the firebox. (Fig. 2)
3.
Once the flame diffusers have been installed, set the cooking grids on the upper
ledges of the firebox in the grill, with the grill bars oriented front to rear.
4.
Install the warming rack above cook grids, on the 2 brackets located on the left & right
inner walls of the inner hood.
◼
INITIAL CLEAN/WIPE DOWN:
Because we use high polish detailing, there may be some residue from the light oily cleaner we use to take off the
protective plastic residue and masking. These marks can be easily cleaned using a 3M or Sprayway stainless cleaner
and a microfiber cloth, always cleaning in the direction of the stainless steel grain. This is a food safe cleaner that is
non-abrasive and will leave your BBQ gleaming. This cleaner can be used for future regular cleaning.
◼
INSTALL FOLDING SIDESHELVES (JKS550 and JKS700
ONLY)
1.
Install two brackets using two screws each on either side of the grill.
2.
Install top bolt.
3.
Hook on shelf and install bottom bolt (Fig. 3).
4.
Install accessory hanging bolts.
5.
Repeat on the other side.
Figure 2
Tip of brass orifice, on
end of valve; correctly
hidden inside burner.
Main burner
Figure 1
Figure 3
