Plasma 25ci
Operating manual
Page 20
22. Table cutting speed
The following table is clue fort he welding speed:
Material thickness
(mm)
Material
Cutting current
(A)
Speed
(m / min)
1,0
steel
10
2,5
2,5
steel
15
1,2
4,0
steel
18
0,6
6,0
steel
25
0,3
0,5
Aluminum
8
3,5
1,0
Aluminum
12
1,9
1,5
Aluminum
18
0,6
2,5
Aluminum
25
0,3
0,5
Stainless steel
8
3,5
1,0
Stainless steel
12
2,2
1,5
Stainless steel
15
1,9
2,5
Stainless steel
20
1,8
4,0
Stainless steel
25
1,3
23. Important notes on IP44 version
Attention:
IP44 means that the cutting device is protected against water (rainfall) from all directions.
It must never be placed in standing water or similar.
Further, the torch is not designed to work waterproof, so this also should not be touched with standing water.
Plasma cutting is performed by means of high voltage and current. Because water conducts electricity, the
cutting surface and its environment must be free of water, and the cutting area to be protected from rain water to
avoid electrocution. It must never be cut in the water.
When working with plasma cutters outdoors or in moist environments, greater attention is needed!
24. Maintenance and safety check
Disconnect mains prior to any service and maintenance work!
The cutting unit is, on principle, maintenance-free. However, make it a rule to carry out the following work:
Check air filter. Change cartridge, if required.
Clean the welding unit by air-blasting from inside according to pollution level.
Attention:
This Welding unit has to be safety checked every year by JÄCKLE Company or another special qualified
electrician according to the harmonized standard
IEC 60974 – 4
Safety, maintenance and inspection of arc welding equipment in use
