②、打线凸轮打线量调整
当需要调节底线打线量时，松开紧定螺钉，调节分线片位置，分线片往上移动打线
量减小，分线片往下运动，打线量增加。（图6）
②、Adjusting thread guides of CAM
When adjusting the base thread distance, first loose screw and adjust
dividing thread plate position. If dividing thread plate moving up ,the
thread distance get less, while vice versa.
图6(Picture 6)
5、机针高度调整
首先调整机针与针板的间隙，保证机针与针板的间隙均等，调整机针高度，机针运
行到最高点，针板到左针针尖的高度为H（图7），H参数如下表：
Dividing thread plate
screw
Dividing thread plate
Summary of Contents for K4-D Series
Page 1: ...K4 D K4 D series use manual...
Page 26: ...8 4 5...
