7.5.
settinG OF GuarD
7.5.1.
Height adjustment is made with the lever mounted on the left side of the machine. After lifting the lock lever the blade cover can be
slide ways to set the required stock width for jointing. Push lock lever down to lock guard extrusion in position fig.7.
7.6.
planinG
7.6.1.
the cutting depth is set by handle l, at the front table plate n, by means of the scale for cutting depth m. set cutting depth between
0.5 and 1.5 mm (1/64~1/16 in.). This will produce the best surface.
WarninG:
the part of the cutter head not used has to be covered by the knife guard.
7.6.2.
take up a working position so that you are always on one side of the machine away from the area directly in front of or behind the
cutterhead. Place both hands on the workpiece with the fingers.
DO nOt
hold on to the workpiece edges. only workpieces that rest
firmly on the machine and can be safely guided, should be planed fig.8.
7.7.
thicknessinG
7.7.1.
set the desired height with handle assembly at spindle with reference to scale. 1 turn =3mm
7.7.2.
slide in narrow wood in the middle.
7.7.3.
When thicknessing the table must be lubricated regularly with lubricant.
7.7.4.
After having worked for a long period or when planing wet wood it may occur that the workpiece stops while pulling in.
WarninG:
switch off the machine immediately in case of failure.
8
DO nOt
remove chips and splinters from the tables while the machine is running.
7.7.5.
short workpieces should not be planed.
7.8.
replacinG BlaDes
WarninG!
disconnect from mains power before performing any maintenance.
7.8.1.
Unplug from mains and turn On/off switch off.
7.8.2. Block the blade guard from closing down.
7.8.3.
loosen and remove three blade lock screws securing blade and blade clamp.
7.8.4.
lift blade and blade clamp from cutterhead.
7.8.5.
clean any sawdust and resin buildup from cutterhead and blade clamp.
7.8.6.
Place blade clamp against the replacement blade and replace in cutterhead.
7.8.7.
secure blade and blade clamp using three blade lock screws.
DO nOt
over-tighten blade lock screws first.
note: check blade height at both ends of the blade.
7.8.8.
tighten blade lock screws.
7.8.9.
recheck blade adjustment and make sure blade is still level with outfeed table.
7.8.10.
repeat the procedure to replace the other blade.
7.8.11.
remove the scrap wood and release blade guard.
7.8.12.
make sure all the blade lock screws are tight and snug.
fig.7
s
M1311 | Issue:2 (H,F) 06/02/18
Original Language Version
© Jack sealey limited
fig.5.4
fig.5.5
fig.5.6
fig.5.7
fig.5.8
r
efit the set screw.
move the guard to the other end of the
working table.
set the safety guard at its top position.
fasten the set screw.
locate the 2 keys on the dust chute to align the with the rectangular holes on both sides of the working table and insert the keys.
fig.8
