7.3.
chip extractiOn
7.3.1.
to ensure trouble free operation on enclosed premises, the machine must be connected to an extractor unit at the dust shute.
7.3.2.
Dust shute connection when planing
WarninG!
Disconnect power supply and turn planner/thicknesser power switch off.
7.4.
Dust chute cOnnectiOnWhilst thicknessinG
WarninG!
Disconnect power supply and turn planner/thicknesser power switch off.
s
M1311 | Issue:2 (H,F) 06/02/18
Original Language Version
© Jack sealey limited
fig.3
fig.4.1
fig.4.2
fig.4.3
fig.4.4
fig.4.5
fig.4.6
fig.5.1
fig.5.2
fig.5.3
set the thicknessing working table at its
lowest position.
insert dust chute under the working
table at an angle.
the edges of the dust chute to be in
line with the edges of the working table.
Pull the keys out from both sides of the
dust chute and locate the dust chute
with its edges in line with the edges of
the working table
carefully insert the dust chute.
Position chute so that 2 keys on
each side can be aligned with the 2
rectangular holes on the side of the
table. ensure the keys are fully inserted
remove the screw on the fence seat.
undo this set screw.
remove the fence assembly.
