background image

SPECIFICATIONS

Model number:

. . . . . . . . . . . . . . . . . . . . .31777-0000

Voltage: 

. . . . . . . . . . . . . . . . . . . . .12 or 24 VDC input

Amps: 

. . . . . . . . . . . . . . . . . . . . . . . . .12 amps at 12 V

6 amps at 24 V

Flow Range: 

. . . . . . . . . . . . . . . . . .Depends on pump

Size: 

. . . 4.7”(115 mm) x 3.4”(85 mm)x 3.0”(73.5 mm)

Weight: 

. . . . . . . . . . . . . . . . . . . . . . . .8.2 Oz (0.23 Kg)

Model 31777-0000 

12/24 VDC Pump Controller

Variable Speed Drive (VSD)

SMOOTH-FLOW™

WATER SYSTEM CONTROLLER

Variable Speed Drive (VSD) converts everyday pumps into
sensor-controlled pumps that automatically adjust in real
time to changes in pressure. As less flow is required, the
pump motor slows down to provide a smooth and
pulsation-free performance.

FEATURES

• Provides smooth and quiet water flow without pulsation

(water hammer)

• Eliminates temperature variation

• Eliminates need for space consuming accumulator tank

• Works on most water pressure pumps rated 3-12 amps

• Easy-to-install; hose and fittings included

• Runs on 12 or 24 VDC input

HOW IT WORKS

The controller automatically measures the pressure at
which the pump’s pressure switch opens. It uses this
measurement to determine an optimal running pressure
for the given pump, and stores the value in its memory
for consistency between power cycles.

Compatible Pump Requirements:

• Diaphragm pumps with 3, 4 or 5 pumping chambers.

• 12 or 24 VDC.

• 12 amp maximum at 12 Volts.

• 6 amp maximum at 24 Volts.

• 3 amp minimum pump rating.

• MPU pressure switch rating: 30 to 65 psi.

• Motor voltage must match system voltage.

• Not compatible with Flojet 4405 and Jabsco

31295/31395 Series pumps.

INSTALLATION & SERVICE INFORMATION

4.60

2.94

3.41

(115)

(73.5)

(85.25)

DIMENSIONAL DRAWING

Dimensions in inches (millimeters)

®

This product is to be used for potable water system applications only. Use
with any other medium, including particularly hazardous, flammable, caustic
or corrosive substances, could result in damage to the unit, the surrounding
environment and injury to persons or property, including possible exposure
to hazardous substance.

WARNING

Summary of Contents for 31777-0000

Page 1: ...t HOW IT WORKS The controller automatically measures the pressure at which the pump s pressure switch opens It uses this measurement to determine an optimal running pressure for the given pump and stores the value in its memory for consistency between power cycles Compatible Pump Requirements Diaphragm pumps with 3 4 or 5 pumping chambers 12 or 24 VDC 12 amp maximum at 12 Volts 6 amp maximum at 24...

Page 2: ...ate Fitting to Facilitate Installation Kit Inventory Tools Required Location Pre install Remove Accumulator Tank if installed System may not operate properly if there is an accumulator tank installed anywhere in the system Mount the VSD Module as close as possible to the pump discharge Kit is set up to mount directly to pump discharge PARTS KEY 1 Water System Hose 2 Pump Elbow Hose 3 Quick Connect...

Page 3: ... itself to the pump in a few seconds The system is then ready to use City Water Inlet optional Water Tank Check Valve used with Water Heater Shower Fixture Sink Faucet Existing Water Pump Low Point Drain Inlet Strainer VSD Smooth Flow Controller Water Heater optional Plumbing Turn off power to the pump Shut off water supply to pump Open faucets and low point drains to relieve pressure in lines Dis...

Page 4: ...pump control and power supply wires and hoses should be placed so as not to interfere with any components for operation of the vessel www jabsco com 30649 1000 SNAP IN PORT x 1 2 MALE QEST STRAIGHT 30654 1000 SNAP IN PORT x 1 2 HOSE BARB STRAIGHT 30653 1000 SNAP IN PORT x 3 4 HOSE BARB STRAIGHT 30650 1000 SNAP IN PORT x GARDEN HOSE STRAIGHT 30655 1000 SNAP IN PORT x 1 2 MALE QEST 90 ELBOW 30651 10...

Reviews: